STEP 1: Mow the lawn.
Start by mowing your lawn. Cut it short, but not so short that you scalp it. If you cut it so that grass blade stems become visible, the grass is vulnerable to drying out.
STEP 2: Examine the amount of thatch at the lawn’s roots, then dethatch as needed.
Take a closer look at your grass roots, and determine the amount of thatch on your lawn. Thatch is the layer of decayed grass and other organic material at the base of the turf. About ¼ to ½ inch of thatch is acceptable, but any more than that will prevent the grass from getting adequate air and water.
If you have more than ½ inch of thatch, remove (or at least significantly loosen) it by systematically running a thatch rake over the surface to pull it up. Or, if your lawn is larger, run a dethatching machine over it. You can rent a dethatching machine from a home improvement store, and it will make the process much quicker.
STEP 3: Mix sand, topsoil, and compost.
Make a top-dressing mix to fill in the area beneath the grass in sunken areas of your lawn from two parts sand, two parts topsoil, and one part compost. The sand helps maintain a level yard because it doesn’t compact easily, while the soil and compost contain nutrients that your grass needs to thrive.
DIY Lawn Care. Simplified.
Bob Vila has partnered with Sunday to get your lawn exactly what it needs to thrive.
STEP 4: Dig up the grass in sunken parts of the lawn and fill with the soil mixture.
If you have any low spots or divots deeper than 2 or 3 inches, you should remove the grass on top of them before filling the holes. Dig up the sod by putting the blade of a shovel into it at the outside of a low spot and sliding it down and under about 2 or 3 inches to get under the grass roots. Then pry the grass up with the shovel to expose the dirt beneath. Fill the hole with the top-dressing mix, and put the grass back into place on top of it.
If some low spots occur near your home, follow a similar process to gently slope the soil away from the foundation. Dig up and rearrange the soil so that it is higher close to the home, but not so high it covers the entire foundation. Then slope it down about 1 inch for every foot away from the house. If the entire yard’s grade slopes toward the house, you might need help properly grading.
STEP 5: Spread the rest of the soil mixture in a thin layer to even out the entire lawn.
Once the lowest patches are filled, use a shovel to disperse the top-dressing mix across your entire lawn to a depth of about ¼ to ½ inch. Even if you think your grass needs more than that depth to even out, err on the side of caution and keep to a thin layer—a heavier layer could choke your grass. If necessary, you can repeat this process (see Step 7) to add a second layer.
Then, spread the top-dressing mix evenly across the grass by pulling and pushing it around with the back of a bow rake. Work the mix into the gradual low spots and pockets when lawn leveling. If the grass blades are completely covered by the mix, the grass will suffocate from light deprivation, so follow up with a push broom to further work the mix into the soil at the base of the turf grass and reveal the blades.
STEP 6: Run the lawn sprinklers.
Water your lawn to help the top-dressing mix settle into the grass and fill any air pockets. Running your lawn sprinklers will also revitalize your lawn because it will jump-start the infusion of nutrients from the compost in the mix.
STEP 7: Reapply the soil mixture as needed.
After a few waterings, look for water runoff or standing water in puddles. You may need more than one application of top-dressing to completely smooth out your lawn. Apply the second layer following Steps 5 and 6 once you see the grass start to actively grow, or when you can no longer see the first top-dressing application you put down.
Final Thoughts
Once you know how to level a yard, it is a worthwhile and relatively simple project to tackle in spring. Ground leveling can bring fun and curb appeal back to your lawn and prevent water waste and water damage to the home.
First determine the cause, and then tackle lawn lumps and low spots with the steps outlined above. If you observe water running toward your home’s foundation, fix the slope. Once you level your yard, ongoing maintenance should be easier.
FAQs About How to Grade a Yard
Yard leveling doesn’t have to be tough, but knowing the steps involved—and tips that make the job easier—always help! We’ve expanded on some here with answers to frequently asked questions.
Q. How do you fix an uneven lawn?
Once you know how to level ground, it is a fairly straightforward process. First, mow the lawn and then identify dips. Fill them with a mix of compost, sand, and topsoil. Dig sod up in high spots and remove some of the soil before adding a thin layer of the same mix and replacing the sod. Top-dress the entire lawn with a ¼- to ½-inch layer of topsoil, and then water. You might have to top-dress again after the soil settles.
Q. How much does it cost to level a yard?
Fixing lumps and bumps caused by foot traffic, digging, plantings, or thatchy grass should cost no more than a few tools and materials. Most tools, such as a shovel and bow rake, probably reside in your shed already. If you don’t have a dethatcher, renting one can run up to $80 a day. Purchasing a manual thatch rake typically runs $40 to $50.
When leveling a yard, sometimes you can move soil from high spots to low areas, but in other circumstances you might need to purchase topsoil and sand to complete the project. A 40-pound bag of topsoil is usually under $10.
Q. When should I level my lawn?
In most cases, spring is the best time to level your lawn. Warm-season grass is coming out of dormancy, and any plugs of sod you dig up and replant after leveling stand a better chance of surviving in spring temps before the heat of summer. If snow melt or spring rains have been heavy, put off leveling until the ground dries out, or you can do more damage in muck and mud.
Q. How do I level my whole yard?
With lawns, mow the grass and fill in low spots while digging out lumps or high spots. Put the grass back in place once level, then top-dress the lawn with a ½-inch layer of compost and level the lawn with the back of a bow rake. Use leveling sand to fix uneven pavers or flagstone paths. If your entire yard has a grade problem, you might need to bring in a yard-leveling professional to slope the property correctly.
Q. What kind of dirt do you use for grading?
In general, removing or tilling the top few 6 to 8 inches of soil can loosen it. Then, mix some new topsoil in with the existing soil. Add enough to form a slope away from the house; generally about 2 percent grade will work. Allow the soil to settle a few days and then check the grade again. Before digging, check for utilities, and if your basement has flooded or the job is complex, consider hiring a professional to grade the yard.
Q. How far should dirt be from the foundation?
Dirt can be near the foundation, as long as it is not too high. Be sure that at least 4 inches of the foundation shows above the layer of dirt. Most important, continue to slope the dirt away from the house, lowering it about 1 inch for every foot of space away from the foundation. If the dirt close to the house is too high, remove enough to expose the foundation so it can dry out, but do not leave a low spot around the home. Instead, continue to remove or rake dirt away from the foundation to create about a 2 percent slope toward the yard. If the dirt level near the foundation is satisfactory, add topsoil near the foundation and gently rake it downward to create the slope.
DIY Lawn Care. Simplified.
Bob Vila has partnered with Sunday to get your lawn exactly what it needs to thrive.